Awning Ledger Board

The ledger should be attached before the foundation is built for a deck patio roof posts and other structure.

Awning ledger board.

Note you will need a minimum of 3 of unobstructed room above the top of the mounting bracket and ledger board for the awning to fit properly this measurement increases to 4 with a. The brackets are then lag bolted to the roof and sealed watertight. Five ledger board techniques explained and illustrated. The ledger board is attached to the roof with 90 degree heavy duty stanley brackets the brackets need to be bent so the new ledger board is plumb.

The placement of the ledger header determines the level of the roof so be sure it is positioned at the correct height and is horizontal. The roof top brackets wood ledger board and lag bolts are to be purchased locally by customer. Find the wall studs or roof trusses that will have to support the ledger. Hammer a 1 by 4 by 8 ledger board on the exterior wall of the house using 16 penny nails.

Step 4 attach an 8 foot metal l shaped ledger to the house and to the ledger board using 1 inch screws. Minimum of 7 6 from the deck or patio to the top of the mounting bracket and ledger board. So make a mark above 7 to 8 inches and keep a minimum gap of 2 inches at one of the ends. Any one of these five ledger connection methods properly installed will give you a reliable long lasting deck that is secure.

Parts of a house attached patio roof. Also you need to keep enough open space approximately 3 4 inches above the top of the mounting bracket and ledger board. This is a time consuming process and should be done while the house is being constructed to simplify the process and reduce costs. A ledger header board is the first step if you are attaching the patio roof to an existing structure.

The ledger typically a 2 by 6 is usually designed to hold one end of the patio roof rafters. In order to install the ledger board you usually need to remove the house s siding. Where to attach a patio roof ledger. Make it the full width of the porch or slightly wider depending on your porch design.

The awning should be at least 7 to 8 feet above the ground or the patio. Make sure the nails go through the wall studs. Locate a position for a header or ledger board. Never install a ledger board over the top of siding no matter what you hear this can weaken the connection.